Camper Tent - Assembly Instructions

Download Pdf

Components

Packed tent in a box

tent bag

t pole with sliding brace

awning pole jintable 2 sections

sprong bar rod x 4

pegs x 16

hammer x 1

Assembly instructions

1

Spread the tent and fix the spring bar rods with ridge pole

2

Fix the ridge pole on roof. Slide the sleeve brace over the pole joint until the push-pins lock the brace into place. Note: to disassemble, push the pin in to slide the brace away from the joint.

3

Mount the side standing pole according to the instruction. Join upright poles

4

Unzip doors to allow air to enter. Raise the tent end and insert the end of the upright pole onto the post on the bottom of the T-pole. Lift the pole and place pole bottom over the pin attached to the D-ring at the bottom of the tent. Repeat the same step on the other side of the tent.

5

Mount and join awning poles. Place the tip of the awning pole through the corner grommet at the end of the awning. Tie a small loop in the end of the guyline. Place loop over the top of the pole. Stake the guyline. Adjust the clasp so guyline is taut. Repeat on other side.