Bell Tent - Assembly Instructions

Download Pdf

Components

Packed tent in a box

tent bag

t pole with sliding brace

awning pole jintable 2 sections

spring bar rod x 4

pegs x 16

hammer x 1

Assembly instructions

1

Spread out the tent cover and loosely attach a few straps to the ground using the tent pegs to ensure that center pole fit easily to the top of the tent. Loosen all guy ropes and close door before you head to the next steps.

2

Open the entrance and place the center pole inside the tent. Place the top of the pole in the center of the roof top and lift up the tent. When erected the bottom of the pole must be placed at the center of the ground, or if you have the floor, in the center of this.

3

Place the door mount pole in the entrance section now. The peak of it needs to be pushed through the eyelet at the roof of entrance. Follow the next steps for tensioning the tent.

4

Erect the tent by inserting all remaining pegs and tighten the guy ropes. Gently tight through the runners. Ensure the door is closed to avoid too much tension on opening.

caRE iNSTRUCTIONS

Wipe down all metal surfaces with fresh water after use. To remove marks, use a soft bursh or sponge with fresh water and mild detergent only and rise with fresh clean water. Allow to dry thoroughly. Never pack away damp, dirty or wet. After beach use or wet conditions treat all zips and metal components with silicon spray.